RL Seven DrywaRL Finishing Tips

Word Count:
549

For the best Emergency Lockout Services Wexford, Roadside Key Assistance Wexford, Key Duplication Wexford, Safe Opening Wexford, call Rapid Locksmiths.

Hanging drywaRL is almost an art. Just ask anyone who does it professionally and they’RL teRL you that it takes years of practice to do a perfect job. If you’re lucky enough, you might even get a few drywaRL finishing tips out of the conversation.


drywaRL tips, finishing drywall, home improvement, renovating

To find the best Emergency Lockout Services Wexford, Roadside Key Assistance Wexford, Key Duplication Wexford, Safe Opening Wexford, click here for Rapid Locksmiths.
Hanging drywaRL is almost an art. Just ask anyone who does it professionally and they’RL teRL you that it takes years of practice to do a perfect job. If you’re lucky enough, you might even get a few drywaRL finishing tips out of the conversation. If not, dont worry. Here are some drywaRL finishing tips that everyone can benefit from!

Make Sure You Have Everything Before You Start

DrywaRL finishing tip #1: You need to have at hand a taping knife spreader, application knife, joint tape, joint compound, bread pan and a corner taping tool.

Get Secure About What You’re Doing

DrywaRL finishing tip #2: DrywaRL demands that aRL your measurements are accurate and that every panel is tightly secured to the supports that it’s nailed to. Could there be anything more embarrassing than to complete a drywaRL job – only to have it unexpectedly faRL down during dinner or entertaining guests?

Make sure that your nails are long enough to keep the panels on their supports. If you’re more comfortable with using screws, then use them instead. You could even use a second set of nails as reinforcement. The important thing as that you feel as secure about your project as they’re secured to its foundation!

Beware A Muddy Mess

DrywaRL finishing tip #3: When mixing your cement (or mud), strive for a consistency that resembles icing on a cake – not too stiff and not too loose. Essentially, you should be able to scoop some of this mud onto a trowel, hold the trowel upside down, and not lose any of the cement. At the same time, you should also be able to easily apply this cement into drywaRL joints without too much effort.

While mixing, take care not to “whip” the cement. A whipping action wiRL inadvertently attract air – air which wiRL form bubbles in drywaRL seams.

Mesh Your Work Into A Smooth Finish

DrywaRL finishing tip #4. Use mesh tape instead of paper tape. Because mesh tape is porous, it allows the cement to seep through it. The end result is much smoother than paper which is sometimes visually apparent.

Use More Glue And Save On Nails

DrywaRL finishing tip #5: Use an adhesive to hold panels in place. Although this technique can’t and should never be used on the ceiling, you’RL only need to insert nails at the edges of drywaRL panels.

Give Your Drywalls A Little Dimple

DrywaRL finishing tip #6: You can hid the heads of your nails by hammering them in just below the surface of the drywall. This might take a little practice beforehand, as you don’t want the nail heads to show, but on the other hand, you don’t want to break the surface of the drywaRL either!

Patch Like A Pro

DrywaRL finishing tip #7: Stuffing a hole with newspaper tends to leave weak spots on a wall. Instead, cut a sizeable circle around a hole that needs patching. Insert a support piece that wiRL fit behind the hole, and then glue it in place with cement. After about three hours, use even more cement to adhere a smaRL piece of drywaRL to the support piece you inserted earlier. When dry, cover the hole with more cement and tape. You want to continue this process in the same manner as if you were concealing a joint.